Select the Automatic mode to have your old disk's partitions automatically and proportionally resized to fit the new disk:.Run Acronis True Image and select Tools & Utilities -> Clone Disk:.Boot the laptop with Acronis bootable media.SolutionĪssuming that you have your new drive installed in the laptop, and the old one connected via USB, here is a sample cloning scenario with Acronis True Image: When booting from the rescue media, you can make sure that Acronis True Image detects both the source and target disks before starting the cloning operation. If this is the case, the cloning operation will fail after reboot. For example, there may be a case when your hard disk drives are detected in Windows and not detected in Linux. Because of this, it is better to clone under rescue media. Įven when you start cloning in Windows, the computer will reboot into the Linux environment the same as when booting from the rescue media. For information on Acronis Bootable Media see Acronis bootable media. You do not even need to have the new drive formatted to do the cloning. When cloning from Acronis Bootable Media, you do not need to have an operating system or an Acronis product installed on the new drive. (!) If you are using Acronis True Image 2017 or earlier, the cloning should be done from Acronis Bootable Media (created on CD/DVD or Flash). the new disk to which you clone, and from which you intend to boot the machine) in a bay, and not physically inside the laptop, the target hard disk will be unbootable after the cloning. As such, hard disk bays cannot be used for target disks. For example, if you have a target hard disk (i.e. If the new disk is inside the laptop, the boot settings will be automatically adjusted to boot from internal disk. Otherwise you will may not be able to boot from the new cloned drive, at Acronis True Image will apply a bootability fix to the new disk and adjust the boot settings of the target drive to boot from USB. It is recommended to put the new drive in the laptop first, and connect the old drive via USB. Ensure Acronis True Image for Western Digital is closed and not running, before starting with the Cleanup Utility.If you have decided to replace the hard disk of your laptop with a new one, you can use Acronis True Image to do the cloning.Uninstall and Remove any other Acronis Software before using the utility. Other Acronis products installed will be damaged by the utility.Acronis Secure Zone must be removed before using the utility.Acronis Startup Recovery Manager must be deactivated before using the utility.Ensure that there is a backup copy of the drive and data.Steps to deactivate Startup Recovery Manager, remove Secure Zone and run the Cleanup Utility are included in Acronis Support Knowledge Base Article: 48668: Acronis True Image: Cleanup Utility If the product fails to be removed using Windows Add/Remove Programs, an Acronis Cleanup Utility can be used.Windows 10: click Start > Settings > System > Apps > Acronis True Image for Western Digital > Uninstall.Windows 11: click Start > Settings > Apps > Apps and Features > Acronis True Image for Western Digital > Uninstall.Remove Acronis True Image for Western Digital for Windows Uninstall Acronis again using the below steps for Windows.Stop Acronis True Image for Western Digital and ensure it is not open and running.Set all configured Backup Jobs to Do Not Schedule to stop and/or pause jobs.Backup and Restore to a WD Network Attached Strorage (NAS).Backup and Restore to a WD Direct Attached Storage (DAS).Acronis True Image for Western Digital User Manual.Configure backups using Acronis True Image for WD using the following resources.When completed, click Next when it appears.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |